IBM Partner Pavilion Proventia Network Enterprise Scanner 2.3 Instrukcja Użytkownika Pobierz pdf (Strona 105)

Suspending and enabling all background scans

You can suspend and enable all scanning for the groups controlled by a Scan

Control policy. This applies to current and future background scans.

About this task

If you stop background scans by disabling all scanning in the Scan Control policy,

all current scans go into the idle status, and no more scans can be scheduled until

you enable scanning again.

The following occurs when you enable scanning again:

Table 21. Effects of enabling scanning during the same or a later refresh cycle

If you... Then...

Enable scanning during the same refresh

cycle

The job runs again in its entirety, or until the

end of the refresh cycle.

Enable scanning during a later refresh cycle

v The job from the previous scan goes into

the expired state at the end of its refresh

cycle.

v If there are interim refresh cycles, no jobs

are started.

v A job is scheduled for the refresh cycle

during which you enabled scanning.

Procedure

1. In the SiteProtector Console, create a tab to display asset policies.

2. In the navigation pane, select a group, and then open the Scan Control policy

for that group.

3. Choose an option:

If you want to... Then...

Suspend scans Clear the Enable background

discovery/assessment scanning of this

group check box in the Background

Discovery and Background Assessment

sections, for the type(s) of background

scanning you want to suspend.

Enable scans Select the Enable background

discovery/assessment scanning of this

group check box in the Background

Discovery and Background Assessment

sections, for the type(s) of background

scanning you want to define.

Chapter 7. Managing scans in SiteProtector 97

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 186 187

Brak uwag

IBM Partner Pavilion Proventia Network Enterprise Scanner 2.3 Instrukcja Użytkownika Strona 105